!: Utility Knife - The Tool You Can't Live Without | !: Electric Pole Chain Saw Reviews Help

!±8± Utility Knife - The Tool You Can't Live Without

From the home and orchad to the carport and basement, home owners often face fix and honey-do projects that require one of the most basic tools - the utility knife. Its versatility and compel makes it a tool no homeowner should be without.

Looking to add insulation in your home to get a deal with on your utility bills? There's nothing like a cold, windy winter to bring out the cracks and areas in your home that could use some additional insulation. You can in fact sacrifice the cost of the project by doing the work yourself.

Assembling the proper tools for the job is pretty straightforward. In expanding to a utility knife, have on hand fiberglass insulation, work gloves, a measuring tape, staplers, a dust mask, and stepladder, if needed. A wooden pole can also be useful if you're going to be pushing insulation into roof rafters or other hard-to-reach areas. Also, if you're working in the attic or other area where there is no light source, use movable clamp lighting.

As you place the insulation in the middle of the studs, joists and rafters, staple it into place. Use scraps of insulation in open areas where heat loss can occur. Your utility knife comes in handy for cutting the insulation when indispensable to fit specific areas. Make sure the insulation is placed paper/foil side down before making any cuts with the utility knife. Ensue up with caulk in areas colse to windows and doors where drafts can get through.

Utility knives are also the tool of option when it comes to replacing worn-out carpeting. Removing rug is a fairly uncomplicated do-it-yourself project, and can save you money if you're having new rug or hardwood installed.

In expanding to a utility knife, have masking tape, a pry bar and hammer on hand. You'll want to begin in a projection of the room where you can pull the rug from the tack strip. Roughly three feet in from the corner, cut a strip of rug wall to wall with your utility knife. Then, begin rolling the cut strip of carpeting, pulling it from the tack strip as necessary. Get the three-foot section with masking tape. Continue cutting and rolling the 3-foot strips until all the rug has been removed. Repeat the same recipe with the rug padding. The pry bar and hammer are good tools for removing the tack strip if you will be replacing the rug with hardwood. Otherwise, the tack strip can remain in place.

Repairing holes in drywall is not an unusual task for homeowners, either. The project is relatively uncomplicated and can make a dramatic improvement in the appearance of your home.

To fix a small hole in the drywall, Get together fiberglass mesh tape, joint compound, a putty knife, sandpaper, and a utility knife. After cutting a 2-inch quadrate colse to the hole with the utility knife, stretch fiberglass mesh drywall tape over the square. Apply a layer of joint mixture and plane it with the putty knife, blending the edges into the wall. Repeat the steps any times to fully cover the hole. Finish up by sanding the final layer with fine-grit sandpaper.

For larger holes, Ensue the first step as above with a utility knife or keyhole saw. Use strips of plywood, cut three to four inches larger than your opening, and fasten inside the quadrate with drywall screws. Part and cut a drywall patch to fit inside the square, followed with fiberglass mesh drywall tape. Apply any layers of joint compound, using the putty knife to plane the ridges in in the middle of coats. As with small-hole repairs, sand the final layer of joint mixture using fine-grit sandpaper.